On your device, you will see a power button below the eyepiece. Hold the power button until you see the lights on the front flash twice. To turn it off, simply hold the same power button down until you see the lights flash again.
Make sure that your Lazer+ is charged and powered on. If the display does not appear or shows blurry, turn the eyepiece clockwise until it becomes clear.
Looking through your rangefinder, you can see a satellite signal on the top of the display. If this is flashing that means that your device is not yet connected to the course. If the satellite is not flashing this means it is connected to the course.
The Lazer+ will auto-hole advance throughout the round. If the Lazer+ is turned on after the first hole, it will connect to either Hole 1 or Hole 10. To filter through the holes, press both buttons on the top of the device at the same time. This adva
There are two different ways to change your display on your Rad Lazer+. When the device is connected to the app:. 1. Press "Settings". 2. Under Mode Options, change the display to your preferred display. 3. Press Save. This will change the display on
Through the Rad Golf app, users can track the last location of their device. 1. Go to "Device Menu". 2. Press "Locate." This will show the last location your device was powered on. 3. "Mark as Lost" will put a lock on the device that will prevent oth
Pressing the "Distance Button" will pinlock whatever you are aiming at. There will be a small buzz when the yardage appears. Pressing and holding the "Distance Button" on the top of the device will activate the advance pin lock. Hold this button down
The Rad Lazer+ does not need batteries. There is a charging cable that comes with your device. On the top of the display, it shows the battery life. When charging, the port on the device is near the power button, when the cable is connected, the ligh