Lazer
FAQ's about the Rad Lazer.
How do I power on/off the Rad Lazer?
To power on the Lazer, press and hold the power button below the eyepiece until the red lights on the front flash twice. To power it off, press and hold the power button again until the red lights flash twice.
Why is the display blurry in my Lazer?
If the display appears blurry, adjust the eyepiece by turning it left or right until it becomes clear.
How do I register and connect my Lazer to the Rad app?
1. Enable Bluetooth on your phone and download the Rad mobile app. 2. In the app, scroll down to “Lazer” and select "Register & Connect Device". 3. Press the red “Connect” button. 4. Once the app says your device is connected, press "Finish."
Why isn’t my Lazer connecting to the app?
The Lazer will stop searching for a Bluetooth connection if one isn’t made within 15 minutes. If you left your Lazer powered on for a bit before connecting it to the app, this might be preventing you from connecting. To restart Bluetooth scanning, po
How can I tell if the Lazer is connected to the app?
If you look into the eyepiece, there is a blinking Bluetooth icon at the top viewfinder beside the battery indicator. When you connect to Bluetooth, the icon will stop blinking.
Can the Lazer be used without the Rad mobile app?
If you aren’t in Play Golf mode in the Rad app and if the Lazer isn’t connected to the app, the front and back distances as well as the hole number will not display in the viewfinder, however the Lazer will still display the distance to the pin when
How does the “Locate" feature work in the Rad mobile app for the Lazer?
Pressing “Locate” in Device Menu in the Rad app displays the last known location before the Lazer was powered off or lost Bluetooth connection with the app. For this feature to work, location needs to be enabled for the Rad app in your phone’s settin
How do I start a round with my Lazer?
Once your Lazer is connected to the Rad app, press “Play Golf” for the Lazer in the app to start a round.
How do I use pinlock?
Aim the Lazer at the pin and press and hold the Distance button (the one with the flag icon on it) to activate pinlock.
How do I manually change holes?
The hole number displayed in the Lazer viewfinder is determined by the current hole the Rad app is on. Both will automatically advance as you play, but if you want to manually switch holes, press the forward or back arrows in the Rad app and the disp
How do I change the settings on my Lazer?
Changing settings from the app:. 1. Press Settings. 2. Adjust the desired settings or select a mode preset. 3. Scroll down and press “Save”. Changing settings from the Lazer:. 1. Hold down the Mode Menu button (the one with the “” icon
My Lazer isn’t connecting to the app anymore. What should I do?
First, try disabling Bluetooth on your phone then enabling it again. If that doesn’t work, try following these steps to reset the connection:. 1. Power off your Lazer and go to your phone’s Bluetooth settings. 2. Press the “i” icon (iOS) or the
Why are the displayed distances on the Lazer off by 10 yards?
Check the Units setting in the app or on your Lazer and make sure it is set to your preferred unit of measurement (yards or meters). To change this from the device itself, look into the viewfinder then press and hold the Mode Menu button (the one wit
How many rounds can I play before I need to charge my Lazer?
While it is recommended you charge your Lazer after each round, your device should last up to 2 rounds before needing to be charged.